|

2000 Mustang GT
HP
STAGE I Kit
Frank Burrell
Bristol, VA
-
HP STAGE II
Kit
-
Garrett 57mm T3/T4 Twin Turbos
-
Tial Twin 38mm Wastegates
-
Bosch Twin Blow off valves
-
42# injectors
-
Accufab 75mm throttle body with plenum
-
SPEC Stage 3 clutch and pressure plate
-
TKO 600 transmission
-
Eibach lowering springs
-
Kumho 265/35 front and 295/35 rear tires
-
Saleen 18" chrome 5-spoke wheels
-
A-pillar gauge pod with boost, oil pressure and
air/fuel ratio gauges
-
Bob White horse decal

This photo proves you can install a turbo kit in your own driveway.....
"I installed the kit in my
driveway, and the car truly runs like a pissed off GORILLA! I knew the car
would be fast, but this is just crazy! I am far from finished, because now
it’s time to perfect this recipe. I need to get the car tuned, so I am
ordering the SCT Livewire ASAP. I will also be ordering half shafts, bump
steer kit, adding a good fuel system and a Typhoon Intake for starters.
That is just the beginning, next will be bigger injectors, 5.0 stroker-kit
with forged internals, and finally a set of Patriot Stage III Heads. My
goal is to attain the 800rwhp range with consistent mid 10’s as the target."
Frank Burrell
Bristol, VA
"Don't try this at home.........???"

CLICK ON THUMBNAILS TO ENLARGE

This pretty much
sums up Frank's feelings about his HP Twin Turbo GT !!

.....Back on the
ground and boosted!
"I
live minutes from Thunder Valley in Bristol, TN., so watch out! I’m
shooting for 9 seconds, brothas!"
|